Posts Tagged route
On some networks, I need to connect to a (firewalled) intranet over wired ethernet, while general unrestricted network access is available over WiFi. Typically I need to stay connected to both networks so as to access machines on the LAN as well as the WWW. Trouble is (at least on my F17 machines) the system is configured to use the ethernet interface (if live) by default for all outbound requests, regardless of whether the WiFi is enabled or not.
This is not a convenient situation as the LAN is often configured to block access to requests going outside the local subnet. This means every time I have to go online, I need to disable my ethernet Iface first! The source of this endless bother can be traced down to the way the system has setup its routing. Just fire up a terminal and issue the following command to get your current routes. In one such run I get the following output:
$ route -n Kernel IP routing table Destination Gateway Genmask Flags Metric Ref Use Iface 0.0.0.0 192.168.11.2 0.0.0.0 UG 0 0 0 p1p1 192.168.0.0 0.0.0.0 255.255.255.0 U 0 0 0 wlan0 192.168.8.0 0.0.0.0 255.255.252.0 U 0 0 0 p1p1
This tells me that the default route for all outbound requests (those that do not specifically match any other rule) is through Iface p1p1 (ethernet or wired LAN). I need this to be set to wlan0 (WiFi) instead.
That is done (as root) by first deleting the existing default route, followed by adding a new rule to route default requests through WiFi:
# route del default # route add -net 0.0.0.0 dev wlan0 gw 192.168.0.1 # route -n Kernel IP routing table Destination Gateway Genmask Flags Metric Ref Use Iface 0.0.0.0 192.168.0.1 0.0.0.0 UG 0 0 0 wlan0 192.168.0.0 0.0.0.0 255.255.255.0 U 0 0 0 wlan0 192.168.8.0 0.0.0.0 255.255.252.0 U 0 0 0 p1p1
The gateway IP for the default route should be the default gateway for your WiFi.
Post these steps, the system will route requests within the LAN through p1p1 (note that this route was already configured for p1p1 in my case and is a stricter rule than all the others, hence is the first to match) and outbound traffic to non-local addresses through wlan0.